Configuration | 35
800-22740 - A - 02-2017
Configuring Encoding Settings
Click Setup CAMERA ENCODE to open the Encoding interface.
Contrast Adjusts monitor window contrast. Select from 0 to 100. The
default setting is 50. The recommended range is 40 to 60.
The higher the value, the higher the contrast. Use when the
video brightness is good, but the contrast is not.
Note The video might become hazy if you select a low
contrast value. If the value is too high, the dark
sections might lose brightness and the light parts
might become overexposed.
Hue Adjusts monitor video brightness and darkness. The default
setting is 50. Select from 0 to 100.
The higher the value, the more contrast between the bright
and dark elements of the monitor.
Sharpness Adjusts the clarity of the image.
The default setting is 1. Select from 0 to 15.
Color Mode Select from several configured color modes such as
Standard, Soft, Bright, Colorful, Bank, and up to four
Customized settings. Selecting a Color Mode will adjust the
hue, brightness, and contrast of the video.
Image Enhance The default setting is 30. Select from 0 to 100.
NR (Noise Reduction) The default setting is 50. Select from 0 to 100.
Table 3-1 Camera Conditions
Setting Description
To Next Page
Loading...
Need help?
General