MPA2C3 Installation Guide 17
Standard Metal Enclosure
The standard metal housing includes a metal enclosure and serveral accessories.
For the detailed information, see Packing List on page 11. This unit can be powered
by the power supply with a backup battery, or by PoE+.
Figure 1-1 MPA2ENCME/MPA2ENCMU Access Control Overview
Note: For MPA2MPSE and MPA4MPSE the 12 VDC Battery must be purchased separately.
Compliance Note
This device complies with Part 15 of the FCC Rules / Innovation, Science and Eco-
nomic Development Canada’s licence-exempt RSS standard(s). Operation is sub-
ject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est con-
forme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouil-
lage est susceptible d’en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Multiple Tie-down Points
Simple Panel Door Removal
for Easy Wall Mounting
and Cabling
Simple Panel Door Removal
for Easy Wall Mounting
and Cabling
10-19 VDC / 50 W
Primary Power Supply
12 VDC Backup Battery
Panel Door Grounding Point
Enclosure Lid Tamper
Off Wall Tamper
All-in Smart Control Panel
(MPA2C3/MP2C3-4)
Multiple Knock-out HolesMultiple Knock-out Holes
Multiple Knock-out Holes
Main Socket USA/ UL Version only
Space for