18 MPA2C3 Installation Guide
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the followingmeasures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / ISED RF exposure requirements, a separation distance of 20 cm or
more should be maintained between the antenna of this device and persons during
device operation. To ensure compliance, operations at closer than this distance is
not recommended.
Les antennes installées doivent être situées de facon à ce que la population ne
puisse y être exposée à une distance de moin de 20 cm. Installer les antennes de
facon à ce
que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’
antenne.La FCC des éltats-unis stipule que cet appareil doit être en tout temps
éloigné d’au moins 20 cm des personnes pendant son functionnement.
To obtain applicable EU Compliance Declaration of Conformities for this product,
please refer to our website http://www.security.honeywell.com/hsce/interna-
tional/index.html.
For any additional information regarding the compliance of this product to any
EU-specific requirements, please contact:
Honeywell Novar GmbH
Johannes Mauthe Strasse 14
72458 Albstadt
Phone 00497431801-0
To Next Page
Loading...
Need help?
General
