Honeywell MPA2C3 Installation Manual

MPA2C3 Installation Guide 33
Figure 3-4 Connecting the Power Supply Cable
Warning: Do not apply power at this time. Ensure the power cable is disconnected from the
external power source before following this step. The battery cable is included in the
accessory bag.
Wire the battery cable, as shown in the below picture.
Figure 3-5 Connecting the Battery Cable – 7 Ah Battery

Honeywell MPA2C3 Specifications

General

Brand	Honeywell
Model	MPA2C3
Category	IP Access Controllers
Language	English