32 MPA2C3 Installation Guide
Wiring to PoE+ Switch
Warning: Use a static strap whenever touching the panel to ensure protection from ESD
(Electrostatic Discharge).
Warning: Do not apply power at this time. Ensure the PoE+ switch is not powered.
1. Connect the Ethernet cable to the RJ45 port Eth1 / PoE+ - HOST
Figure 3-3 Connecting the Ethernet Cable for PoE+
Wiring to Power Supply and Tamper Connector – Standard Metal Enclosure
Warning: Use a static strap whenever touching the panel to ensure protection from ESD
(Electrostatic Discharge).
Warning: Do not apply power at this time.
Connect prepared low voltage power supply cable (red, black) to the PSU terminals
(V+, V-). Ensure to secure the power cable by the cable clamp.
To Next Page
Loading...
