MPA2C3 Installation Guide 91
The below figure shows the connection and relevant jumper setting when external
power source is used to the outputs in a 4-door panel
Figure 3-27 the connection and relevant jumper setting when external power source is
used to the outputs in a 4-door panel
Wiring the MPA2S5 cables to a door
The MPA2C3 Metal enclosure kits include multiple MPA2S5 door connection
cables, one for each door.
The MPA2S5 is designed to connect a CAT cable (via the RED RJ45 Terminal) easily
to the internally (panel) powered door locking device, the door contact and the REX
/ Egress button.
To Next Page
Loading...
