Honeywell ST 800 - 4.4 Changing the Default Failsafe Direction; 4.4.2 Procedure to Establish Failsafe Operation

Page 44 ST 800 SmartLine Pressure Transmitters User’s Manual Revision 10
Install Date
<Return>
Year
# # # #
Enter the current year.
This item will only be visible if no
Install Date has been written to
the transmitter.
Month
January thru
December
Select the current month.
This item will only be visible if no
Install Date has been written to
the transmitter.
Day
# #
Enter the day of the month.
This item will only be visible if no
Install Date has been written to
the transmitter.
Install Date
dd-mmm-yyyy
If no Install Date has been set in
the transmitter, this value is a
preview of the Year, Month, and
Day entered above. Otherwise,
this is the Install Date that was
previously written to the
transmitter.
Write Date
Press ENTER to write the Install Date to the
transmitter.
CAUTION: The Install Date can only be written once
in the life of the transmitter. You cannot erase or
overwrite the Install Date once it has been written.
PILD
(Available
only if the
PILD Option is
enabled)
<Return>
PILD
Disabled
Disables PILD
detection
Press  to
enter menu
selection
 and  to
select
Disabled or
Enabled.
 to initiate.
This option
will be
available only
if sensor
supports
PILD feature
Enabled
Enables PILD detection
Application
<Return>
See Note below.
Press  to
enter menu
selection
 and  to
select
Application
Type.
 to initiate.
DP Flow (Available only
for DP Transmitter)
Marine Level
Bubbler Level
Other