MAN0984_Iss 4_01/19 Touchpoint Plus
Pt. No. 3011M5001 96 Technical Handbook
7.10.3 To Change Inhibit Timeouts
1) Log in as Administrator or Service
2) Touch a channel, then touch the Settings icon:
3) Touch [Next] repeatedly until you reach page 7/7, as shown below:
4) Touch the chosen value, enter a new value, and touch [Finish]>[Finish]>[Apply]
Refer to Ch.15 Icon Glossary for further information.
Note: Inhibit timeout setting is available in the Configuration menu. Inhibit timeout will not work for inhibits activated
by the remote inhibit input or the signal of an input channel gas sensor.
7.11
Viewing Input Channels and Input
Details
From the Input screen, toggle the icon between Channel Tile>Channel Summary>Channel Output.
1) From the Input screen, select Channel List or Channel Tile.
2) A list of all input channels is shown in order of channel ID. The channel ID, gas name, status, min/max peak gas
concentration and current reading will be shown.
3) The list can be filtered by status Alarm, Fault, Inhibit, Warning or All.
4) Touch a channel and the Channel detail (left below) screen will appear. Depending on access level, a number of
options will be shown (see Ch.15 Icon Glossary for Icon names):
To Next Page
Loading...
Need help?
General
