Installation
8 UDC2300 Universal Digital Controller User Manual 4/00
Mounting Method
Before mounting the controller, refer to the nameplate on the outside of the case
and make a note of the model number. It will help later when selecting the proper
wiring configuration.
Panel
20752
Figure 2-3 Mounting Method
Mounting Procedure
Table 2-4 Mounting Procedure
Step
Action
1
Mark and cut out the controller hole in the panel according to the dimension
information in Figure 2-2.
2
Remove the screw cover and loosen the screw on the front of the controller.
Pull the chassis out of the case.
3
Orient the case properly and slide it through the panel hole from the front.
4
Remove the mounting kit from the shipping container and install the kit as
follows:
• Install the screws into the threaded holes of the clips.
• Insert the prongs of the clips into the two holes in the top and bottom of the
case.
• Tighten both screws to secure the case against the panel.
• Carefully slide the chassis assembly into the case, press to close, and
tighten the screw. Replace the screw cover.
To Next Page
Loading...
