EasyManuals Logo

Honeywell UDC 2300 User Manual

Honeywell UDC 2300
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Operation
46 UDC2300 Universal Digital Controller User Manual 4/00
4.6 Timer
Introduction
The Timer provides a configurable Time-out period of from 0 to 99 hours:59 minutes or
0 to 99 minutes:99 seconds.
Timer Start is selectable as either the RUN/HOLD key or Alarm 2.
The Timer display can be either Time Remaining or Elapsed Time.
Configuration check
Make sure:
TIMER is enabled
A TIMEOUT period has been selected (in hours and minutes or minutes and
seconds)
A TIMER FUNCTION START has been selected (KEY or AL2)
A TIMER display has been selected (Time remaining or Elapsed time)
A timer increment selected
Timer reset selected
Refer to Subsection 3.3 for details.
Viewing Times
The times are viewed on the lower display as follows:
TIME REMAINING will show as a decreasing Hrs:Min value (HH:MM) or Min:Sec
value (MM:SS) plus a counterclockwise rotating clock face.
ELAPSED TIME will show as an increasing Hrs:Min value(HH:MM) or Min:Sec
value (MM:SS) plus a clockwise rotating clock face.
Operation
When the Timer is enabled (RUN/HOLD key or ALARM 2), it has exclusive
control of Alarm 1 relay.
At TIME-OUT:
Alarm 1 is active
The clock character has stopped moving
The Time display shows either 00:00 or the time-out period depending on
the configuration selection
The Timer is ready to be reset.
At RESET:
Alarm 1 relay is inactive
The time display shows the time-out period
The time-out period can be changed at this time using the or keys.
The Timer is ready to be activated.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell UDC 2300 and is the answer not in the manual?

Honeywell UDC 2300 Specifications

General IconGeneral
BrandHoneywell
ModelUDC 2300
CategoryRemote Control
LanguageEnglish

Related product manuals