Operation
4/00 UDC2300 Universal Digital Controller User Manual 53
4.14 Entering a Security Code
The level of keyboard lockout may be changed in the Set Up mode. However,
knowledge of a security code number (0 to 4095) may be required to change
from one level of lockout to another. When a controller leaves the factory, it has
a security code of 0, which permits changing from one lockout level to another
without entering any other code number.
If you require the use of a security code, select a number from 0001 to 4095 and
enter it when the lockout level is configured as NONE. Thereafter, that selected
number must be used to change the lockout level from something other than
NONE.
CAUTION
Write the number on the Configuration Record Sheet in Appendix C
so you will have a permanent record.
Table 4-13 Procedure to Enter a Security Code
Step Operation Press Result
1 Enter Set Up
Mode
SET UP Upper Display = SET UP
Lower Display = TUNING
2 Select any Set
Up Group
FUNCTION Upper Display = 0
Lower Display = SECUR
3 Security Code
Entry
[▲] [▼] To enter a four digit number in the upper display
(0001 to 4095)
This will be your security code.