Operation
58 UDC2300 Universal Digital Controller User Manual 4/00
Step Operation Press Result
[▲] [▼]
until you change the input selection in the upper display back to
the proper selection. You will see:
Upper Display = Original Input Selection that matches your
type of sensor.
Lower Display = INxTYP
4
Return to Normal
Operation
DISPLAY
to return to Normal operating mode.
The factory calibration will be restored. If the problem is not
corrected, contact the Honeywell Technical Assistance Center.
1-800-423-9883 USA and Canada
To Next Page
Loading...
Need help?
General
