To Next Page

To Previous Page

4/00 UDC2300 Universal Digital Controller User Manual vii

Tables

Table 2-1 Preliminary Checks __________________________________________________3

Table 2-2 Control Relay Contact Information ______________________________________6

Table 2-3 Alarm Relay Contact Information _______________________________________6

Table 2-4 Mounting Procedure _________________________________________________8

Table 2-5 Permissible Wiring Bundling __________________________________________10

Table 2-6 Universal Output Functionality and Restrictions ___________________________10

Table 3-1 Configuration Procedure _____________________________________________21

Table 3-2 TIMER Group (Numeric Code 100) Function Prompts ______________________22

Table 3-3 TUNING Group (Numeric Code 200) Function Prompts_____________________23

Table 3-4 SPRAMP Group (Numeric Code 300) Function Prompts ____________________25

Table 3-5 ATUNE Group (Numeric Code 400) Function Prompts______________________27

Table 3-6 ALGOR Group (Numeric Code 500) Function Prompts _____________________28

Table 3-7 INPUT1 Group (Numeric Code 600) Function Prompts _____________________29

Table 3-8 INPUT2 Group (Numeric Code 700) Function Prompts _____________________31

Table 3-9 CONTRL Group (Numeric Code 800) Function Prompts ____________________32

Table 3-10 Options Group (Numeric Code 900) Function Prompts ____________________34

Table 3-11 Communications Group (Numeric Code 1000) ___________________________35

Table 3-12 ALARMS Group (Numeric Code 1100) Function Prompts __________________37

Table 4-1 Annunciators ______________________________________________________39

Table 4-2 Lower Display Key Parameter Prompts__________________________________40

Table 4-3 Error Messages ____________________________________________________41

Table 4-4 Single Display Parameters ___________________________________________43

Table 4-5 Procedure for Starting Up the Controller_________________________________44

Table 4-6 Procedure for Switching Between Setpoints ______________________________45

Table 4-7 Set Up Procedure __________________________________________________48

Table 4-8 Procedure for Switching PID SETS from the Keyboard _____________________48

Table 4-9 Procedure for Displaying Alarm Setpoints________________________________49

Table 4-10 Procedure for Displaying 3Pstep Motor Position__________________________50

Table 4-11 Procedure for Setting a Failsafe Value _________________________________51

Table 4-12 Procedure for Setting a Failsafe Mode _________________________________52

Table 4-13 Procedure to Enter a Security Code ___________________________________53

Table 4-14 Background Tests _________________________________________________55

Table 4-15 Restore Factory Calibration__________________________________________57

Table 5-1 Running A Setpoint Ramp____________________________________________60

Table 5-2 Program Contents __________________________________________________62

Table 5-3 Run/Monitor Functions ______________________________________________66

Honeywell UDC 2300 User Manual

Questions and Answers: