HP Compaq nc6000 - Notebook PC Hardware Guide

Hardware Upgrades
Hardware Guide 8–9
If replacing the existing memory in the primary memory slot,
you must remove any memory in the memory expansion
slot first.
If you are adding memory to the memory expansion slot,
proceed to step 9.
8. To remove a memory module from the memory
expansion slot:
a. Pull the retention clips 1 away from each side of the
module. The module tilts upward when released.
b. Lift the edge of the memory module 2, and gently
remove it from the slot.
Ä
To protect a memory module after it has been removed,
place it in a static-safe container.
Repeat step 8 to remove the memory module from the
primary memory slot, if necessary.
333644-001.book Page 9 Thursday, July 10, 2003 2:56 PM

HP Compaq nc6000 - Notebook PC Specifications

General

Processor	Intel Pentium M
Chipset	Intel 855PM
Storage	30 GB to 60 GB HDD
Hard Drive Interface	ATA-100
Battery	6-cell Lithium-Ion
Operating System	Windows XP Professional
RAM	256 MB, upgradable to 2 GB
Graphics	ATI Mobility Radeon 9600
Display	14.1-inch
Display Resolution	1024 x 768 or 1400 x 1050
Optical Drive	DVD-ROM, CD-RW/DVD Combo, or DVD±RW
Networking	10/100/1000 Ethernet
Ports	2 x USB 2.0, VGA, parallel, serial, headphone, microphone