7
Preliminary Requirements
Before you
start
to
reconfigure your CD ROM drive, refer
to
Chapter
3
and
4
to
1.
Shut
down your controller's application
program
and
operating system.
2.
Turn
OFF
your controller
and
unplug all cords
and
cables from
it
and
any
attached
expanders.
3. Access
the
controller's
internal
assemblies.
Model
362
Controllers
There
is one
jumper
on
the
low-resolution system
board
for on-board graphics
configuration.
The
jumper
is marked
ENABLE.
The
default condition is nearest
the
marking. Moving
the
ENABLE
jumper
causes
the
on-board graphics circuitry
to
be
disabled, allowing a
supported
graphics
board
to
be used
in
the
DID slot.
Refer
to
Figure
7-1
for
jumper
positions.
Figure 7-1. Model 362 System Board Graphics Jumper
7 -2 Configuring Graphics Mode
To Next Page
Loading...
