HP 382 Hardware Configuration Guide

10
Setting the Interrupt Level.
SKIP?
The interface is preset to interrupt level 3. Unless you
are certain
that interrupt level 3 is inappropriate for your
.application, leave
the interrupt level setting alone and skip to
to
the next configuration function.
1. Find the group of eight switches on the interface by referring to Figure 10-7.
Switches 2 and 3 in this group determine the interrupt level.
2. Set the interrupt level to the desired value by referring to Table 10-14:
Table 10-14.
Interrupt Switch Switch
Level
2
3
3 0 0
4
0
1
5
1 0
6
1 1
Setting the Remote Switch.
SKIP?
If you are not connecting your system console to port 1 of
this interface, skip to step 5. The Remote switch is preset to
"local," which does not configure port 1 to be the system
console.
1. Find the group of eight switches on the interface by referring to Figure 10-7.
Switch 1 in this group is the Remote switch.
10-26 Configuring Popular Accessory Cards

HP 382 Specifications

General

Brand	HP
Model	382
Category	Desktop
Language	English