3. Set these switches
to
one of
the
four select codes given
in
Figure 10-6, unless
you have used
them
elsewhere. Refer
to
the
installation note
that
came with
the
interface
if
you need additional switch settings.
Select Code
23
Select Code
24
Select Code
26
Select
Code
30
Figure 10-S.
High-Speed HP-IB Interface Card Select Code Switch Settings
4. Make a note
that
the
select code has been used and is no longer available.
5.
Find
the
new select code's
number
in
the
set of select code labels supplied
with
the
interface. Replace
the
card's select code label
with
this
new label.
If
a
number
is
not
available, make a label
that
looks like
the
one removed
and
stick
it
on
the
high-speed HP-IB card.
Setting the Interrupt Level.
SKIP?
If
you are not using HP-UX,
the
interrupt
level is preset
to
6
and
need
not
be changed.
If
you will be using HP-UX continue
with this section.
1.
Find
the
set of nine switches by referring
to
Figure 10-5. Switches 6
and
7
in
this group determine
the
interrupt
level.
2.
If
using HP-UX, set these switches
to
interrupt
level 4 as shown
in
Figure 10-5. To get
interrupt
level 4, set
the
left switch
to
0
and
the
right
switch
to
1.
Do not set any other interface to interrupt level
4.
Configuring Popular Accessory Cards 10-19
10
To Next Page
Loading...
