HP 382 - HP 98622 A GPIO Interface Card Switches and Jumpers

o
o
-
-
PCT(I]L·
PFLG -=:::J
PSTS c::::.
HSH -=:::J
DIN -=:::J
OOU c::::.
1 0
o
[i]
c::::. 0
c::::. ·
-=::J •
~ 4- 1
U38
0
SIT I·~ 19
I· : • 11 CODE §i ~
~ { ~~Y [I1c::::.
...J ROY -=::J
eJ { RD c::::.
:t BSY -=:::J
::> ROY -=::J
c::::. 0 --+--------+-1'= 11
1 0 r::::1= 0°
U39
Interrup Level Switch
~ Fl
• + 5V. 4A
Burst enabled i
jumper is removed
BURS1
Figure 10-1. HP 98622A GPIO Interface Card Switches and Jumpers
Setting the Select Code.
1. Remove the GPIO card from the controller or expander and place it on a
static-free surface.
2. Find the set of five switches labeled U38 on the GPIO Interface as shown in
Figure 10-1. This group of switches determines the select code.
3. Set these switches to one of the four select codes given in Figure 10-2, unless
you have used them elsewhere. Refer to the installation note that came with
the interface if you need additional switch settings.
Configuring Popular Accessory Cards 10-5
10