10
Setting the System Controller Switch.
SKIP?
Unless you
intend
to
connect two controllers together
with
this
interface, you can skip
to
the
next set
of
configuration switches.
The
interface is configured
to
be system controller
and
need
not
be changed.
1.
Find
the
set
of
nine switches
be
referring
to
Figure 10-5. Switch 8
in
this
group determines
the
system controller setting.
2.
If
connecting two controllers together via HP-IB, only one
of
them
may
be
set
to
system controller. To change this interface
to
non-system controller,
move
the
system controller
switchshown
in
Figure 10-5
to
the
0 position
(the
opposite
of
that
shown).
Note:
If
you will
be
connecting a disk drive, printer,
plotter
or
other
peripheral to this interface, and you will be using
an
HP
Series 200/300
operating
system,
do
not
set this switch
to
non-system controller.
Setting the Low jHigh Speed Switch.
SKIP?
The
Low/High Speed switch is preset
to
0,
"high speed," as
shown
in
Figure 10-5. This setting is
appropriate
for most
applications.
If
you want
to
change this setting, continue
with
this section.
Otherwise skip now
to
the
next configuration switch settings.
1.
Find
the
set
of
nine switches by referring
to
Figure 10-5. Switch 9
in
this
group is
the
Low/High Speed switch.
2.
Set
this
switch as follows:
• To set this switch
to
"low speed," set switch 9
to
1,
which is opposite
of
that
shown
in
Figure 10-5 .
• To set this switch
to
"high speed," set switch 9
to
0 as shown
in
Figure
10-
5.
10-20 Configuring Popular Accessory Cards
To Next Page
Loading...
