2. Set
the
Remote switch as follows:
•
If
you are connecting a terminal
to
port
1
of
this interface
and
want
the
terminal on
port
1
to
be
the
system console, set this switch
to
1 (remote),
which is
opposite
that
shown
in
Figure 10-7.
Be aware
that
the
boot
ROM will not recognize this
terminal
as
the
system console, even
though
HP-UX will.
No
boot ROM messages will
appear
on
the
associated terminal; therefore, do
not
use
the
HP 98642A as
a system console
until
after HP -UX is installed.
•
If
you are connecting a
terminal
to
port
1 of this interface
but
do
not
want
the
terminal
on
port
1
to
be
the
system console, set this switch
to
0
(local) as shown
in
Figure 10-
7.
Reinstalling the 4-Port Multiplexer Card
Insert
the
multiplexer interface, component side up, into
its
slot.
Tighten
the
thumb
screws on
the
metal
end
plate
until
the
end
plate
is flush
with
the
back
of
the
controller.
Verification Test
1.
Plug
in
your controller's power cord
and
video cable,
then
turn
on your
monitor
and
controller.
2.
When
the
keyboard line appears, press
(space
bar) a few times
to
go
into
attended
mode.
3. Check
the
interfaces listed on
the
left-hand side
of
the
screen:
•
If
the
message, HP98642, is listed, you have correctly installed
the
multiplexer interface card.
•
If
the
message above does not appear, check
the
installation procedure
and
configuration settings, making sure
there
are
no
select code conflicts
and
that
the
card is firmly seated
in
an
even-numbered slot.
If
the
message still does
not
appear, call your HP Service Representative for
assistance.
Configuring Popular Accessory Cards 10-27
10
To Next Page
Loading...
