HP 382 - Copying Files Using ftp

11 Reconnect the video cable and
power cord to their rear panel
connectors on
the controller.
Verifying the Upgrade
Follow these steps to verify your memory upgrade:
1. Turn ON your controller.
2.
Enter attended mode by pressing (Space Bad when the keyboard line appears
in the power-up display.
3.
Note the amount of RAM in bytes listed in thepower-up display. The
amount should be what you upgraded to. If the amount is correct, turn off
your controller and reinstall in its normal position.
If it is not, check your RAM board installation.
Memory Configurations 5-9
5