Configuring
the
HP
E1440A
Using this Chapter
This chapter provides instructions on preparation for use and how
to install the HP
E1440A
module. It also includes information
about initial inspection and damage claims, packaging, storage and
shipment.
Before operation, the instrument and manual, including the red
safety page, should be reviewed for safety markings and instructions.
These must then be observed to ensure safe operation and to
maintain the instrument in safe condition.
............................................................
Inspection
2-1
........................................................
Configuration
2-2
Changing Module Settings
...................................
2-4
Installation
..........................................................
2-5
-
l
nspection
Warning
Inspect the shipping container for damage. If the container or
cushioning is damaged, it should be kept until the contents of the
shipment have been checked for completeness and the instrument has
been verified both mechanically and electrically.
Procedures for checking the operation of the instrument are given
in Chapter
1
Getting
Started.
If the contents are incomplete,
mechanical damage or defect is apparent, or if an instrument does
not pass the operator's checks, notify the nearest Hewlett-Packard
office. Keep the shipping materials for carrier's inspection. The
HP office will arrange for repair or replacement without awaiting
settlement.
To avoid hazardous electrical shock, do not perform electrical tests
0
when there are signs of shipping damage to any portion of the outer
enclosure (covers, panels, etc.).
Configuring the
HP
E1440A
2-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com