HP 8168E - Page 107

5
:SYSTem:TIMe
Syntax :SYSTem:TIMe < wsp >< value > , < value > , < value >
where
the rst value is the hour,
the second value is the minute, and
the third value is the seconds.
Description This command sets the time.
:SYSTem:TIMe?
Syntax :SYSTem:TIMe?
Description This query returns the current time in the format HH:MM:SS,
where HH is the hour, MM is the minute, and SS is the seconds.
Example OUTPUT 724;":SYST:TIM 16,15,00"
:TRACe Commands
:TRACe:CATalog?
Syntax :TRACe:CATalog?
Description This query returns a string with a list of the traces stored in the
instrument. At the moment, this is only CC_UNCAL .
Note
The trace for the maximum power trace is not available using
:TRACe commands because of the large number of data points.
Use the :POWer? MAX query to get data points for particular
wavelengths.
Example OUTPUT 724;":TRAC:CAT?"
ENTER 724; A$
Remote Commands 5-37