HP 8168E - Display Commands

5
*WAI
Syntax *WAI
Denition The wait-to-continue command prevents the instrument from
executing any further commands, all pending operations are
completed. There is a delay of approximately 0.1 seconds
between the completion of the nal operation and the parsing
of the next command.
Example OUTPUT 724;"*WAI"
:DISPlay Commands
:DISPlay:ENABle
Syntax :DISPlay:ENABle < wsp > OFF j ON j 0 j 1
Description This command enables or disables the front panel display.
Set the state to OFF or 0 to switch the display o, set the state
to ON or 1 to switch the display on. The default is for the
display to be on.
:DISPlay:ENABle?
Syntax :DISPlay:ENABle?
Description The query returns the current state of the display.
A returned value of 0 indicates that the display is o. A
returned value of 1 indicates that the display is on.
Example OUTPUT 724;":DISP:ENAB ON"
OUTPUT 724;":DISP:ENAB?"
ENTER 724;A$
5-16 Remote Commands