EasyManuals Logo

HP 8168E User Manual

HP 8168E
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
D
Test Failure
If the HP8167A/8D/8E/8F fails any performance test, return the instrument to
the nearest Hewlett-Packard Sales/Service Oce for repair.
Instrument Specication
Specications are the performance characteristics of the instrument which
are certied. These specications, listed in Appendix C, are the performance
standards or limits against which the HP 8167A/8D/8E/8F can be tested.
The specications also list some supplemental characteristics of the HP
8167A/8D/8E/8F. Supplemental characteristics should be considered as
additional information.
Any changes in the specications due to manufacturing changes
, design, or
traceability to the National Institute of Standards and T
echnology (NIST), will be
covered in a manual change supplement, or revised manual. Such specications
supercede any that were previously published.
General
Make sure that all ber connectors are clean
Turn the instruments on, enable the laser and allow the
instruments to warm up until STABILIZING is no longer shown
on the display.
Wavelength Tests
Connect the TLS (DUT) to the Wavelength Meter as shown in Figure D-1.
Note
The connector housings for the patchcord cannot be screwed
fully onto the wavelength meter.
This does not aect the wavelength measurements.
Performance Tests D-3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 8168E and is the answer not in the manual?

HP 8168E Specifications

General IconGeneral
BrandHP
Model8168E
CategoryComputer Hardware
LanguageEnglish

Related product manuals