HP 8168E - Page 247

F
Device-Specic Errors
These are error messages in the range -300 to -399, or between 1 and 32767.
They indicate that an error has been detected that is specic to the operation of
the tunable laser source.
A device-specic error is signaled by the device-specic error bit (bit 3) in the
event status register.
-300 Device-specic error. This indicates that a device-specic error has
occurred. No more specic information is available
.
-310 System error. An instrument system error has occurred.
-311 Memory error. A memory error has been detected.
-314 Save/recall memory lost. The nonvolatile data saved by the *SAV
command has been lost.
-315 Conguration memory lost. The nonvolatile conguration data saved by
the instrument has been lost.
-330 Self-test failed. Further information about the self-test failure is available
by using *TST? .
-350 Queue overow. The error queue has overowed. This error is written to
the last position in the queue, no further errors are recorded.
Error Messages F-7