HP 8168E - Page 82

5
Table 5-4. Reset State (Default Setting)
Parameter Reset Value
HP 8167A HP 8168D HP 8168E HP8168F
Wavelength 1310nm 1540nm 1540nm 1540nm
df 0GHz
Display Mode nm
Power minimum
*
Power/Attenuation Mode Power
Unit (Power)  W
Modulation Timing External
Modulation Status O
*
The minimum value is determined, individually for each instrument at calibration.
Example OUTPUT 724;"*RST"
*SAV
Syntax *SAV < wsp >< location >
1  location  5
Denition The instrument setting is stored in RAM. You can store settings
in locations 1-5. The scope of the saved setting is identical with
the scope of the standard setting described in \*RST".
Example OUTPUT 724;"*SAV 3"
*SRE
Syntax *SRE < wsp >< value >
0  value  255
Denition The service request enable command sets bits in the service
request enable register that enable the corresponding status
byte register bits.
The register is cleared:
At power-on
By sending a value of zero.
The register is not changed by the *RST and *CLS commands.
5-12 Remote Commands