Operation
Verification
Software
This software performs a quick automated verification
of
the
HP
8647A
functionality. The software uses the HP
8902A
measuring
receiver and HP
11722A
power sensor to verify the HP
8647A
level
accuracy, modulation accuracy, and dc
FM
frequency stability.
These tests supply a high degree
of
confidence that the HP
8647A
is
functioning correctly. The software is a subset of the performance
tests that are described in chapter
8.
For
a complete calibration,
all
performance tests and data points described in the performance test
chapter must be verified. Whenever there is any doubt about the
performance
of
the HP
8647A,
the manual performance tests should
be used to resolve the issue.
This software is provided without any warranties or support.
It
may
be copied or modified
so
long
as
it is not reproduced for sale.
The software is a large program with many compiled subroutines. The
software must be run under HP
BASIC 6.0
using an HP series
200
or
300
computer. The memory required for the program is approximately
6
MBytes. The HP part number for the software
is
08647-10001.
5-2
Service
To Next Page
Loading...
