HP 8647A - AM Accuracy Performance Test

AM Accuracy Performance Test
AM Accuracy
Performance
Tkst
Connect the Test
Equipment
HP 8647A under test
0 0000 @
Measuring Receiver
Figure 8-3. AM Accuracy Equipment Setup
Configure the
Measuring Receiver
Configure the
HP
8647A
Measure Depths
1. Reset
2. AM mode
3. Peak+ detector
4. 300 Hz high-pass filter
5. 15 kHz low-pass filter
1. Turn AM on; press
2. Set the rate; press (-1.
3. Turn the RF output on; press I-).
[MOD ON/OFF].
1. Enter the amplitudes, frequencies and depths shown in the test
2. Record the test results and compare the results to the limits in the
record.
test record.
8.6 Performance Tests