HP 8647A - HP 8647 A SCPI Command Reference

HP 8647A SCPI
Command
Reference
Terms
<NRf>
<NRl>
<AM term>
<freq term>
~
<angle term>
<amp1 term>
[command]
Wble 2-2. Dictionary of Terms
DescriD tion
Indicates an ASCII representation of a number if required
in the command statement. The number may be an integer
or floating-point, and may include a decimal exponent. (nrf
stands for “flexible numeric representation”. For further
information, refer to the IEEE
488.2 standard.)
Indicates an ASCII representation of
a number if required
in the command statement. The number must be an integer
and may not include decimal points. For further
information, refer to the IEEE
488.2 standard.)
Indicates that a
“PCT” termination is required in the
command statement.
If no termination is specified, a “PCT”
value is assumed.
Indicates that
a “HZ”, ”KHZ”, “GHZ”, or “MHZ”
termination is required in the command statement. IF the
command is not terminated then
“HZ” is assumed.
~~ ~~
Indicates that a “RAD” termination is required in the
command statement. If no termination is specified then
“RAD” is assumed.
Indicates that a “DB”, “DBM”, “DBUV”,
“UV”, “MV”, “V”,
“UVEMF”, “MVEMF”, or “DBUVEMF” termination is
required in the command statement.
If no termination is
specified then “DBM” is assumed.
Bracketed commands are optional. SCPI assumes the
optional command
is present.
Parameters separated by
“1” indicates that either parameter
is acceptable.
Parameters separated by
“, ” indicates that multiple
parameters
are allowed.
HP-IB Programming 2-13