la
Operation
Examples
This section contains operating examples to help you learn how to
operate the signal generator. These examples can be performed
without any additional equipment.
G
metting
Started
If
this is the first time you have operated this instrument, perform
each of the following examples for a quick introduction to general
operation. After you have completed the examples, try operating the
instrument’s remaining functions on your
own.
If
you have trouble
or want additional information on a function, refer to Chapter
lb,
“Operation Reference.”
If
a message
is
displayed that
you
do not
understand, refer to Chapter
IC,
“Operation Messages.”
Operation Examples
1.
Setting the RF Output Signal
2.
Incrementing or Decrementing the RF Output Signal
3.
Using the Memory Registers
4.
Offsetting the RF Output from a Reference
5.
Holding the Output Attenuator Range
1
2
3
4
5
Operation Examples
la-1
To Next Page
Loading...
Need help?
General
