Remote Interface
3.
Sequence Selection
Arrows
Press
a
or
a
to select the next or previous sequence of registers.
The sequences are selected in numeric order. The number
of
the
selected sequence appears in the second line of the FREQUENCY
display. When a sequence is selected, the first register in the sequence
is recalled. When a sequence is selected that has no registers saved in
it, two dashes
(-
-)
will
appear in the REG field.
4.
Register Recall
Press
or
a
to recall the operating settings saved in the registers
Arrows
in the currently selected sequence. The number of the last register
accessed appears in the REG field.
If
two dashes
(-
-)
appear in the REG field, a sequence that has no
registers saved in it
has
been selected.
After the last register in the sequence has been recalled, the register
count will begin again at the first register saved in the sequence.
(Refer
to
"MEMORY" in this section for further information about
register sequences.)
Operation Reference
1
b.23
To Next Page
Loading...
