Line
100
This command outputs
a
query for the RF frequency
setting. You may attach
a
question mark
(?)
to any
of
the signal generators' commands to query its setting.
This command enters the queried frequency setting
into the variable Freq-set.
This command prints the queried frequency setting.
Line
200
Line
300
Programing
RF
OI-ITF'I-IT
719;
"POW:
HMPL
-47
DE:M;
:
OUTP:
STHT
i:it4J"
Amp1itude
P0W:AMPL This command programs the RF amplitude. POW is
higher than AMPL in the command hierarchy and
is
separated
by
a colon. The signal generator's RF
amplitude will be programmed to
-47
dBm.
0UTP:STAT
ON
This command changes the
RF
amplitude to an on
state. The RF amplitude defaults to an
off
state when
the instrument is powered on.
HP-I8
Programming
2-5
To Next Page
Loading...
