HP 8647A - CW Frequency Accuracy Equipment Setup

CW Frequency
Accuracy
Performance
Tkst
(Option 1E5 Only)
Connect the Test
Equipment
HP 8647A under test
Measuring Receiver
Figure 8-12. CW Frequency Accuracy Equipment Setup
Configure the 1. Reset
Measuring Receiver 2. Frequency mode
3. Special Function 7.1. Press (7J 0
Configure the HP
1. Turn modulation off; press (MOD ON~OFF).
8647A 2. Set the amplitude; press @ m.
3. Turn the RF output on; press Cm).
Measure the
Frequency
1. Enter the frequencies shown in the test record.
2. Record the test results and compare the results to the limits in the
test record.
8.1 8 Performance Tests