HP 8647A - Spurious Equipment Setup; Spurious Performance Test

Spurious Performance Test
Spurious
Performance 'kst
Connect the Test
Equipment
ptest3.dm
!4 rn P30co:ll 00000
HP 8647A under test
Configure the
Spectrum Analyzer
Configure the
HP
86478
Measure Spurious
Levels
Figure 8-9. Spurious Equipment Setup
1. Frequency span 500 kHz
2. Res BW 1 kHz
3. Video BW 1 kHz
1. Turn the RF output on; press (-1.
2. Turn modulation off press CMOD ONIOFF).
1. Measure the levels of the spurious signals shown in the test record.
2. Convert the measured levels to decibels below the fundamental
(dBc) and compare the results to the corresponding limits.
Performance Tests E-15