HP 8647A - Output Subsystem

Subsystem :FREQuency
C:CW I :FIXedl?
[:CW I :FIXedl
This function selects a frequency for the continuous wave non-swept
signal. *RST value
is 100 MHz.
CNRf> [<freq term>]
OUTPut Subsystem Omput
: STATe?
:STATe
ON I OFF I 1 I 0
This function controls the state of the RF output. When
0UTPut:STATe is OFF, the RF source level is set to
off. Turning
0UTPut:STATe
ON causes the programmed CW signal to be present at
the output terminal. *RST value is OFF.
2-16 HP-18 Programming