Installation 44
To remove a fan, turn the handle counterclockwise to the unlock position, and pull the fan out of the
enclosure.
Installing Onboard Administrator modules
The HP BladeSystem c7000 Enclosure is shipped with one HP BladeSystem Onboard Administrator with
KVM module installed and can support up to two Onboard Administrator modules. Install Onboard
Administrator modules based on the total number ordered:
• One Onboard Administrator module: Bay 1
• Two Onboard Administrator modules: Bays 1 and 2
Install an Onboard Administrator blank in an unused Onboard Administrator bay.
NOTE:
When two Onboard Administrator modules are installed, the module installed in Bay 1
is active and the module installed in Bay 2 is redundant.
To install an Onboard Administrator module:
1. Remove the Onboard Administrator blank, if present.
a. Press the button on the front of the blank to release the handle.
To Next Page
Loading...
