HP Compaq dc7100 DT - Type 3 Battery

8–30 361288-003 Service Reference Guide, dc7100
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
8.20.3 Type 3 Battery
1. Pull back on the clip 1 that holds the battery in place, then remove the battery 2.
2. Insert the new battery and position the clip back in place.
✎
After the battery has been replaced, use the following steps to complete this procedure.
3. Replace the computer access panel.
4. Plug in the computer and turn on power to the computer.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
Refer to the Computer Setup (F10) Utility Guide.
CHeck R&R
process