EasyManuals Logo

HP Compaq dc7100 DT User Manual

HP Compaq dc7100 DT
290 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
6–8 361288-003 Service Reference Guide, dc7100
Removal and Replacement Procedures - Convertible Minitower (CMT) Chassis
6.7 Front Drive Bezels
1. Prepare the computer for disassembly (Section 6.1).
2. Remove the access panel (Section 6.5).
3. Remove the front bezel (Section 6.6).
6.7.1 5.25” Drive Bezel Blank
Gently pull the subpanel, with the bezel blanks secured in it, away from the front bezel, then
remove the desired bezel blank.
Ä
CAUTION: Hold the subpanel straight when pulling it away from the front bezel. Pulling the subpanel
away at an angle could damage the pins that align it with the front bezel.
To install a bezel blank, reverse the removal procedure.
When replacing the subpanel, ensure that the aligning pins and any remaining bezel blanks are in
their proper orientation. The logo in the subpanel should be located at the bottom of the subpanel
when properly oriented.

Table of Contents

Other manuals for HP Compaq dc7100 DT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dc7100 DT and is the answer not in the manual?

HP Compaq dc7100 DT Specifications

General IconGeneral
Processor SpeedUp to 3.8 GHz
ChipsetIntel 915G
MemoryUp to 4 GB DDR2 SDRAM
Operating SystemWindows XP Professional
Form FactorDesktop
ProcessorIntel Pentium 4
Storage40 GB to 160 GB SATA
GraphicsATI Radeon X300 SE
Optical DriveDVD-ROM
AudioIntegrated audio
NetworkIntegrated Gigabit Ethernet
Expansion Slots1 PCI Express x16
Ports1 Parallel, 1 Serial, 2 PS/2, 1 VGA

Related product manuals