To Next PageTo Next Page
Need help?Do you have a question about the HP HPE ProLiant ML110 Gen9 and is the answer not in the manual?
General| Processor Sockets | 1 |
|---|---|
| Memory Slots | 8 DIMM slots |
| Processor | Intel Xeon E5-2600 v3/v4 |
| Chipset | Intel C610 |
| Memory | DDR4 SmartMemory |
| Storage | Up to 8 LFF or 16 SFF drives |
| Storage Controller | Dynamic Smart Array B140i or P440ar |
| RAID Support | RAID 0, 1, 5, 10 with optional controller |
| Network | 1GbE |
| Expansion Slots | PCIe slots |
| Form Factor | Tower |
| Operating System Support | Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware |
| Maximum Internal Storage | 16 TB |
Describes the components on the front of the server, including optical drives and USB connectors.
Details the components located on the rear of the server, such as power supplies, NIC connectors, and PCIe slots.
Identifies and describes various components found on the server's system board, including connectors and slots.
Explains the numbering scheme for drive bays based on different drive configurations supported by the server.
Provides definitions for the LEDs on hot-plug drive carriers, indicating drive status and activity.
Outlines the procedures for safely powering down the server for maintenance or upgrades.
Provides safety precautions and steps for removing the server's access panel before internal component access.
Details the procedure for removing and installing the server's front bezel to access internal components.
Explains how to remove the system air baffle to gain access to internal components for servicing.
Describes the ideal environmental conditions for installing and operating the server for optimal performance.
Specifies clearance and airflow considerations for installing the server in tower or rack configurations.
Details the recommended operating temperature ranges and conditions for the server.
Outlines electrical and power connection requirements for server installation, including safety guidelines.
Highlights critical warnings and cautions related to server handling, weight, and electrical safety.
Provides general guidelines for installing hardware options and refers to specific installation instructions.
Covers the installation of different drive cage options, including 4-bay LFF and 8-bay SFF configurations.
Details the process for installing hot-plug drives, including preparing and inserting the drive.
Explains how to connect drive cables for various configurations, including HBA and Smart Array controllers.
Discusses the server's embedded storage controller and options for installing additional storage controllers.
