Hardware options installation 52
Smart Storage Battery holder option
To install the component:
1. Power down the server (on page 17).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Place the server on its side.
4. Remove the access panel (on page 17).
5. If installed, remove the PCI air baffle (on page 20).
6. Remove the system air baffle (on page 21).
7. Remove the slot covers.
8. Install the Smart Storage Battery holders.
9. Install the system air baffle (on page 22).
To Next Page
Loading...
