Chapter 5
Troubleshooting
Command Line Interface
97
Troubleshooting Example Using CLI
This example uses the cli and the SEL to display error messages indicating that no memory is installed.
cli>sl e
# Sev Generator/Sensor Description Event ID Data, Timestamp
---- - ---------------- ------------ ----------- --------------------------
00A0 - SFW FW error 00-0F:70:40 3F:-- 2003-10-31 22:29:06
00B0 7 CPU0 Mem no DIMMs 000D0 DT 00 0000000000000000
00C0 7 CPU0 Mem no DIMMs 000D0 Time 2003-10-31 22:29:06
00D0 - SFW FW error 00-0F:70:40 3F:-- 2003-10-31 22:29:06
00E0 7 CPU0 Halt boot 00037 DT 04 000000000000000F
00F0 7 CPU0 Halt boot 00037 Time 2003-10-31 22:29:06
Troubleshooting Example Using CLI
This example uses the cli and the SEL to display error messages indicating that fan 2 (memory fan) has
failed.
cli>sl e
# Sev Generator/Sensor Description Event ID Data, Timestamp
---- - ---------------- ------------ ----------- --------------------------
0010 - BMC Chass cntrl 00-12:70:A3 81:03 2003-10-31 22:39:02
0020 - BMC LPC reset 00-12:70:02 2003-10-31 22:39:03
0030 - Fan 1 (PSU) OK 11-0A:07:00 2003-10-31 22:39:04
0040 - Fan 3 (CPU) OK 13-0A:07:00 2003-10-31 22:39:04
0050 - ACPI State S0 (on) FA-22:6F:00 2003-10-31 22:39:05
0060 - SFW Boot start 00-1D:0A:00 2003-10-31 22:39:05
0070 2 CPU1 Boot start 00063 DT 04 0000000000000000
0080 2 CPU1 Boot start 00063 Time 2003-10-31 22:39:05
0090 - BMC LPC reset 00-12:70:02 2003-10-31 22:39:07
00A0 - SEL Time Set Set FD-C0:03:01 2003-10-31 22:39:15
00B0 - Fan 2 (Mem) Fail (crit) 12-0A:07:02 2003-10-31 22:39:24
00C0 - BMC Chass cntrl 00-12:70:A3 00:E2 2003-10-31 22:39:31
00D0 - ACPI State S5 (off) FA-22:6F:05 2003-10-31 22:39:32
To Next Page
Loading...
Need help?
General