Chapter 4
Utilities
Management Processor Command Interface
66
IMPORTANT Do not mix HP and vt100 terminal types at the same time.
Set up the remote serial port parameters as follows:
• MODEM PROTOCOL: Bell or CCITT (CCITT is a European standard; RTS/CTS signaling is used, as well
as the Ring signal. Bell is a U.S. or simple mode).
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400, 115200
bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
• TRANSMIT CONFIGURATION STRINGS: Disable this setting whenever the modem being used is not
compatible with the supported modem (MT5634ZBA).
• MODEM PRESENCE: When the modem may not always be connected, set this parameter to “not always
connected”.
For example: A modem attached through a switch. In mode “not always connected,” no dial-out functions
are allowed: DIAL-BACK is disabled, and PAGING is not possible.
The MP mirrors the system console to the MP local, remote/modem, and LAN ports. One console output
stream is reflected to all of the connected console users. If several different terminal types are used
simultaneously by the users, some users may see strange results.
Example 4-19 HP-UX
Applications that care about the terminal type (install, SAM, vi, and so on) running on HP-UX use three
methods to determine the terminal type:
1. The application takes the terminal information from the OS. This value is set in the CA command and
takes effect for all MP ports.
2. The $TERM shell environment variable.
3. The application directly queries the terminal (in this case, the write enabled terminal establishes the
terminal type).
Make sure that settings #1 and #2 agree with your terminal type.
Certificate Generate
CG: Generate RSA key pair or Self Signed Certificate
This command generates a new RSA key pair and self signed certificate.
Console Log
CL: Console Log—view the history of the Console output
This command displays up to 60 Kilobytes of logged console data (about 60 pages of display in text mode) sent
from the system to the Console path.
Command Mode
CM: Command Mode—enter command mode
To Next Page
Loading...
Need help?
General