Chapter 4
Utilities
Management Processor Command Interface
69
Flow control timeout is 0 to 60 minutes. If set to 0, no timeout is applied. This timeout prevents mirrored flow
control from blocking other ports when inactive.
Configure LAN Console
LC: LAN configuration (IP address, and so on)
This command displays and allows modification of the LAN configuration. Configurable parameters include:
•MP IP Address
•MP Host Name
• Subnet Mask
• Gateway Address
• Web Console port number
•Link State
The MP Host Name set in this command is displayed at the MP command interface prompt. Typically the
DNS name for the LAN IP is entered.
This field can be programmed to any useful name or phrase. For clarity, it is useful to enter MP-on-SYSTEM as
the MP Host name, so both names show up in the prompt (limit 19 characters, no spaces allowed.) The web
access port number is also set by this command.
Locator LED Status
LOC: Locator LED Status
This command displays the current status of the Locator LED.
LAN Status
LS: LAN Status
This command displays all parameters and the current status of the MP LAN connections. The LAN
parameters are not modified by the execution of this command.
Return to Main Menu
MA: Return to MP Main Menu
This command makes the MP return to the non mirrored MP Main Menu. This is the same as executing
CTRL+B.
Modem Reset
MR: Modem Reset
This command makes the MP send an AT Z command to the modem, which resets it. Any modem connections
are lost. The initialization results can be viewed via the MS command.
Modem Status
MS: Modem Status—Display modem status
To Next Page
Loading...
Need help?
General