Chapter 4
Utilities
EFI/POSSE Commands
44
Syntax
monarch <cpu>
Parameters
<cpu> specifies a cpu
Operation
If specified with no parameters, monarch displays the Monarch processor for the system. Specifying a
processor number alters the preferred Monarch processor. None of these changes takes affect until after a
reboot.
Example 4-15 monarch Command
Shell> monarch
Current Preferred
Monarch Monarch Possible Warnings
------- --------- -----------------
00
00
To view monarch: fs0 :\ monarch
| Processor
-----------------+-----------
current status | 0
next boot status | 0
To set the monarch processor to 1: fs0 :\ monarch 1
| Processor
-----------------+-----------
current status | 0
next boot status | 1
pdt
Displays or clears the contents of the Page Deallocation Table.
Syntax
pdt (clear)
Parameters
<clear> clears the pdt
Operation
With no options specified, the command displays the PDT information for the system. The PDT is cleared and
a reboot is required for memory reallocation and safe booting.
Example 4-16 pdt Command
Shell> pdt
PDT Information
Last Clear time: PDT has not been cleared
Number of total entries in PDT: 50
Number of used entries in PDT: 0
To Next Page
Loading...
Need help?
General