Chapter 4
Utilities
Management Processor Command Interface
64
TOPics : Show all MP Help topics and commands
HElp : Display this screen
Q : Quit help
Enter one of the commands described above: OV, LI, <command>, TOP, HE, Q
Management Processor Commands
MP commands are listed in the following table and described in the following paragraphs.
Table 4-7 Management Processor Commands and Descriptions
Command Description
BP Reset BMC passwords
CA Configure asynch/serial ports
CG Certificate generator
CL View console log
CM Select command mode
Ctrl+B Return to MP main menu
CO Select console mode
CSP Connect to service processor
DATE Date display
DC Default configuration
DF Display FRU information
DI Disconnect remote or LAN console
FW (XU) Upgrade MP firmware
HE Display help for menu or command
ID System information
IT Inactivity timeout settings
LC LAN configuration
LOC Locator LED display and configuration
LS LAN Status
MA Return to Main Menu
MR Modem reset
MS Modem status
PC Remote power control
PG Paging parameter setup
To Next Page
Loading...
Need help?
General