Chapter 4
Utilities
Management Processor Command Interface
72
Table 4-8 defines alert (or severity) levels.
Security Options
SO: Configure security options and access control (users, passwords, and so on)
This command modifies the security parameters of the MP, which include login time-outs and allowed
password faults.
If configured, when you access the MP via the modem port, the MP hangs up and dials the user back. This
does not work if Modem Presence is set to not always connected with the CA command.
If the mode is Single, the State is changed to disabled after the first login.
A disabled user’s login is not accepted.
System Status
SS: Displays the status of the system processors
The SS command displays the status of the system processors and which processor is the monarch.
Firmware Revision Status
SYSREV: Displays the revision status of firmware in the system.
This command displays the revision status of firmware in the system.
NOTE At the time of production of this guide, the firmware revisions were:
FIRMWARE INFORMATION
Firmware Revision: 1.10 [4341]
PAL_A Revision: 7.31/5.37
PAL_B Revision: 5.37
SAL Spec Revision: 3.01
SAL_A Revision: 2.00
SAL_B Revision: 1.10
Table 4-8 Alert Levels
Severity Definition
0 Minor forward progress
1 Major forward progress
2Informational
3Warning
5 Critical
7 Fatal
To Next Page
Loading...
Need help?
General