HP NonStop SSH Reference Manual STN Reference • 265
• ACTION: Correct the error, then stop and restart STN, or use STNCOM command to directly enter any
required configuration commands.
zstn-evt-backup-started value is 6
"<STN process name> Backup created in cpu <2>"
• CAUSE: STN created a backup process (a) after startup time when PARAM BACKUP is used, (b) after
STNCOM BACKUPCPU command, (c) after a takeover, or (d) after a backup CPU became available.
• EFFECT: STN is now operating with a backup process.
• ACTION: None; informational only.
zstn-evt-backup-stopped value is 7
"<STN process name> Backup stopped"
• CAUSE: The STN backup process stopped. Another EMS event may give additional information.
• EFFECT: STN runs without a backup. In some cases, STN will automatically restart the backup process
immediately or after a backup CPU becomes available.
• ACTION: If backup operation is required, make the backup CPU available or use the STNCOM command
BACKUPCPU to select another backup CPU.
zstn-evt-backup-start-err value is 8
"<STN process name> Backup create error <2> <3>"
• CAUSE: STN could not create a backup process due to process_create_ error codes <2>/<3>
• EFFECT: STN runs without a backup. In some cases, STN will automatically restart the backup process
immediately or after a backup CPU becomes available.
• ACTION: If backup operation is required, make the backup CPU available or use the STNCOM command
BACKUPCPU to select another backup CPU.
zstn-evt-misc value is 9
"STN requires SAFECOM ADD DISKFILE <1>,PRIV-LOGON ON but it is <2>"
<1> - The STN object filename
<2> - SPI Error
Safeguard not running
Not configured
DISKFILE record not found
DISKFILE PRIV_LOGON OFF
• Cause: STN object not properly configured under Safeguard.
• Effect: STN cannot start dynamic service applications when SERVICE USER or LOGON is used.
• Action: Start Safeguard, then perform the following Safecom command for the STN object file:
To Next Page
Loading...
