268 • STN Reference HP NonStop SSH Reference Manual
• EFFECT: PARAM TRACE^SIZE is ignored, so the trace file is opened with the default size.
• ACTION: Reorder the PARAM list. STNCOM commands can be used to stop and restart the trace using the
desired size without shutting down STN.
zstn-evt-reply-error value is 21
"<STN process name> Reply error <2>"
• CAUSE: An unexpected file system error <2> was returned by REPLYX.
• EFFECT: Usually none, unless other errors are noted.
• ACTION: If the problem persists, contact support.
zstn-evt-stopping value is 22
"<STN process name> Process stopping - SHUTDOWN command"
• CAUSE: The STNCOM command SHUTDOWN was entered.
• EFFECT: The STN process terminates. The backup process, if any, is stopped first. Any active sessions are
immediately terminated.
• ACTION: Restart STN.
zstn-evt-cpuswitch value is 23
"<STN process name> Primary process stopping - CPUSWITCH command"
• CAUSE: The STNCOM command CPUSWITCH was entered.
• EFFECT: A backup takeover occurs, and the old primary becomes the new backup.
• ACTION: None; informational only.
zstn-evt-enter-debug value is 24
"<STN process name> Process entering debug"
• CAUSE: The STNCOM command DEBUG was entered.
• EFFECT: The STN process enters inspect/debug at its current home terminal. This will suspend all STN
operation and can timeout any active sessions if the debug state is not exited within a short time.
• ACTION: The DEBUG command is generally used only by development and support staff.
zstn-evt-exit-debug value is 25
"<STN process name> Process exiting debug"
• CAUSE: An inspect session from a previous DEBUG command finished.
• EFFECT: STN operation continues. Active sessions may timeout if the time spent in inspect mode was too
long.
• ACTION: None; informational only.
To Next Page
Loading...
