HP NonStop SSH Reference Manual STN Reference • 267
zstn-evt-trace-stop value is 15
"<STN process name> Trace stopped"
• CAUSE: An STN trace was stopped.
• EFFECT: None; informational only.
• ACTION: The binary trace file may now be forwarded to support, or may be formatted using the GTRED
program.
zstn-evt-trace-segment value is 16
"<STN process name> Trace not started to <2> size <3> allocatesegment error <4>"
• CAUSE: Error <4> encountered when allocating extended segment file <2> of size <3> bytes.
• EFFECT: Tracing is not enabled.
• ACTION: Correct any errors in the trace filename, or select a disk with more available space, then retry the
TRACE command.
zstn-evt-trace-object value is 17
"<STN process name> Trace not started to <2>; error reading object file"
This event is no longer used.
zstn-evt-takeover value is 18
"<STN process name> Backup process takeover due to: <2>"
• CAUSE: STN backup process takeover. <2> specifies the reason, such as primary CPU failure, etc.
• EFFECT: Backup process resumes STN operation. Any sessions active in the previous primary process are
lost. New sessions will be accepted immediately. Depending on backup CPU availability, a new backup
process is automatically started.
• ACTION: If the reason for the backup takeover, such as primary CPU failure, is understood, then no action is
required. Otherwise, contact support.
zstn-evt-trace-error value is 19
"<STN process name> Trace not started to <2> size <3> error <4> / <5>"
• CAUSE: An unusual error was encountered while opening a trace file.
• EFFECT: Tracing is not enabled.
• ACTION: Contact support. Retry the TRACE command.
zstn-evt-trace-size-file value is 20
"<STN process name> PARAM TRACE^SIZE must precede PARAM TRACE^FILE"
• CAUSE: PARAM TRACE^SIZE followed PARAM TRACE^FILE
To Next Page
Loading...
